CONTENTS
Introduction
1 NAMES AND FUNCTIONS OF PARTS
2 BASIC SCANNER OPERATION
3 SCANNING VARIOUS TYPES OF DOCUMENTS
4 DAILY CARE
5 REPLACING CONSUMABLES
6 TROUBLESHOOTING
7 ONLINE SETUP
7.1 Online setup
7.2 Double-feed detection
7.3 Setting of Page Edge Filler
7.4 Setting dropout color
7.5 Setting of pre-pick mode
7.6 Resetting the consumables counters
7.7 Adjusting the offset
7.8 Adjust the magnification
7.9 Power saving
8 DOCUMENT SPECIFICATION OF ADF
9 OPTIONS
10 SCANNER SPECIFICATIONS
Appendix
7.1 Online setup (Continued from the previous page)
The following shows the contents of the setup:
No Meaning Description Selectable parameter The initial value
4
Dropout Color
Use this function to drop out a color in
Grayscale or Binary mode.
Red/Green/Blue/White Green
5
Pre pick
Select "Yes" to enable Prepicking,
otherwise select "No".
YES/NO YES
6
Consumable counter
You can estimate the service life of
consumables by checking these
counters. Be sure to reset the counter
when you replaced any consumable.
To reset
7
Offset adjustment
Set the horizontal and vertical offset for
scanning.
ADF(front)/ADF(back)/Flat bed
Main: -2 to 3 (can be changed by
0.5mm)
Sub: -2 to 3 (can be changed by
0.5mm)
Right & left : 0mm
Top & bottom : 0mm
8
Vertical magnification Adjustment
Set the magnification of a scanned
image.
ADF/Flat bed: -6.3% to 6.3%
(can be changed by 0.1%)
0%
9
Power saving
Set the waiting time for the scanner to
switch into the power save mode
You can set the waiting time
from 5 minutes to 55 minutes
(can be changed by 5 minutes)
15minutes
1 | 2
All Rights Reserved, Copyright (C) PFU LIMITED 2003
To Next Page
Loading...
