Fujitsu fi-6400 - Page 77

Index
Chapter 4 Various Ways to Scan
Appendix
Glossary
Introduction
Contents
TOP
77
How to Load
Documents
Daily Care
Troubleshooting
Operational
Settings
Replacing
Consumables
Scanner
Overview
Various Ways
to Scan
How to Use
the Operator
Panel
7 Select an application to be launched by the [Send to] or
[Scan] button event and an operation to be performed.
Click [Start this program] under [Actions], and select an application
from the menu shown on the right.
8 Click the [OK] button.
The setup of the computer is completed here. Proceed to configure
the scanner settings.
Scanner settings
 [Scan] button
No particular setting is required.
 The specified application starts when the [Scan] button is pressed.
 [Send to/Pause] button
In the [Main Menu] of the operator panel, change the setting number
for the [Send to/Pause] button which is displayed on the LCD.
Match the number with the scanner button event configured in the
computer ([Send to 01] to [Send to 50]).
For instance, display "F02" in the LCD's indicator to execute an event
configured for [Send to 02].
 The specified application starts when the [Send to/Pause] button
is pressed.
 The windows that appear and the operations differ by
the operating system that you are using.
 To configure multiple buttons, repeat steps 5 to 8.
 For more details about the operator panel, refer to "Chapter
3 How to Use the Operator Panel" (page 45).
 For information on how to change the setting number for
[Send to/Pause] button, refer to "3.3 Function Selection"
(page 66).
Function
/Enter
Check
Menu
Scan
Stop
Eject
Counter
ResetiMFF
Send to
/Pause
Clear
/Back
[Send to/Pause] Button
[Scan] Button