Setting the remote controller address manually
NOTES:
• Perform manual address setting only when setting the address with an arbitrary number. In-
door unit remote controller address setting is necessary. Set the remote controller address of
indoor units connected by the same remote controller cable within a range of 1 to 9 and A
(10) to F (15) so that there is no duplication. (Do not set to "0".)
• The address of this unit is set within a range of 1 to 32, but set it so that it does not duplicate
the remote controller address of an indoor unit connected by the same remote controller ca-
ble.
1. To activate the address setting mode, hold down the three buttons of “MENU”, “<“, and “EN-
TER” at the same time for 2 seconds or longer. Menu 2 setting screen is displayed.
2. Select the “15” in Menu 2 settings. Then press the “ENTER” button.
3. The address of this unit is displayed on the screen. Set the unit number with the “+” or “-”
buttons. System number cannot be changed.
“ ” is displayed:
Address automatically
Remote controller address
allocated
Not displayed:
Address manually
allocated
01 to 32
Press the “ENTER” button to return to the Menu 2 item selection screen.
DESIGN & TECHNICAL MANUAL
- 38 -
DUCT TYPE
ARHG72-90LHTA
To Next Page
Loading...
