Fujitsu GENERAL ARHG72LHTA - Page 44

¢
Remote controller master/slave setting
NOTE:
Set only one Master remote controller.
1. To activate the address setting mode, hold down the three buttons of “MENU”, “<“, and “EN-
TER” at the same time for 2 seconds or longer. Menu 2 setting screen is displayed.
2. Select the “06” in Menu 2 settings. Then press the “ENTER” button.
3. Select the “0: Master” or the “1: Slave” with the “+” or “-” buttons.
: Master : Slave
4. Press the "ENTER" button. If there is no problem, return to Menu 2 items selection screen.
In the case of settings at initial booting, "Monitor mode screen" is displayed.
• There's 0 or more than 2 "Master" units: The number will be displayed.
• "Master" is 0: Press the "ENTER" button to return to the Menu 2 item selection screen.
• "Master" is more than 2: Press the "ENTER" button to return to the screen of step 2.
• "Master" is 0 or more than 2: Press the "MENU" button to return to the Menu 2 item selec-
tion screen.
Number of Master units
DESIGN & TECHNICAL MANUAL
- 40 -
DUCT TYPE ARHG72-90LHTA