Working with the no tebook
Handling data carriers
Handling
Observe the following guidelines when handling data carriers:
• Avoid touching the surface of a data carrier. O nly handle data carriers by their edges.
• Always store data carriers in their cases. This will protect the data carrier against
being covered in dust, scratched or da maged in any other way.
• Protect your data carriers against dust, mechanical vibrations and direct sunlight.
• Avoid storing a data carrier in areas subject to high temperatures or humidity.
You can use data carriers with a diameter of 8 cm / 3.15" or 12 cm / 4.7" in the drive .
When using a data carrier of lesse r quality, vibrations and reading errors may occur.
CD/DVD indicator
CD/DVDindicator
The C D/DVD indicato r
flashes when a data carrier is inserted. The indicator goes out when
the drive is ready for
reading. The indicator lights up when the drive is being accessed.
You may only remove t
he data carrier when the indicator is unlit.
If the CD/DVD indica
tor does not go out aft er a data carrier has b een inserted , but
instead cont inues
to flash, this means that the drive cannot access the da ta carrier.
Either the data ca r
rier is damaged or dirty or y ou are using a data
carrier that the d
rive cannot read.
32 Fujitsu
To Next Page
Loading...
