Removing and inst alling components
during servicing
Attaching the cover
2
2
1
2
2
2
2
2
2
► Place the cover into position, following the direction of the arrow (1).
The screws of the memory cover and the hard disk cover a re different lengths.
When installing the cover, you must use the co rrect screws.
If you install the wrong screws, components ma y be damaged.
► Secure the cover with th e screws (2).
Finishing component removal
After you have removed or changed the system components as you required, please
prepare y our device for operation again as follows:
► Install the battery again (see "
Inserting battery", Pag e 31).
► Turn the notebook the right way up again and place it on a flat surface.
► Reconnect the cables that you disconnected before.
Fujitsu 53
To Next Page
Loading...
