Removing and installing components
during servicing
Removing and installing mem ory
expansion
MemorymoduleMainmemoryMemoryremovalSystemexpansionSystemexpansion
If you are asked by the Hotline/Service Desk to rem ove or install a memory
expansion module yourself, p roceed as follows:
Please observe the safety information in chapter "Important notes", Page 16.
During installation/removal of memory modules, the battery must remain
removed from the notebook and the notebook must not be connected to the
AC adapter, see "
Preparin g to remove components", Page 63.
Only use memory modules that have been approved for use in your
notebook (see chapter "
Technical data", Page 81).
Never use force when installing or removing a memory mod ule.
Make sure that no foreign objects fall into the me m ory upgrade compartment.
You mu st open the mem ory upgra de comp artmen t to remove or install a memory
module. On some devices, it is possible that opening the compartment exposes various
components. Only autho rized specialists are permitted to remove or change these
components. Therefore, be sure to ob serve the fo llowing:
Individual components can become very hot during operation. Therefore, we
recommend that you wait one hour after switching the notebook off before removing
or installing memory modules. O therwise , there is a risk of suffering burns!
As some components are exposed that are sensitive to static electricity, please take
note of chapter "
Notes on installing and removing boa rds and compone nts", Page 62.
Removing a memory module
3
2
1
1
► Carefully pu sh the two m oun ting
clips outwards (1).
Memoryexpa
nsion
Memorymodu
le
The memory module will fold upwards (2).
► Pull the memory module out of its slot
in the direction of the arrow (3).
Fujitsu 65
To Next Page
Loading...
