Removing and installing components
during servicing
Installing and removing memory
expansion
MemorymoduleMainmemoryRemovingmemorySystem expansionSysteme xpansion
If you are asked by the Hotline/Service Desk to remove and install the memo ry
expansion yourself, proceed as follows:
Please ob se rve the safety information in c hapter "Important notes", Page 12.
When installing/removing memory modules, the battery must be rem oved from
the notebook and th e notebook must not be connected to the power supply,
see "
Preparing t o rem ove components", Page 53.
Only use mem ory expansion modules that have been approved for your
notebook (see "
Technical data", Page 67).
Never use force whe n installing or removing a memory extension.
Make sure that foreign objects do not fall into the memory extension compartment.
You must open the service compartment to remove or install a memory module. On some devices,
opening the compartment may expose other components. These components should be removed
and replaced only by authorised specialists. Therefore, be sure to observe the following :
Individual components can become very hot during operation. Therefore, we
recommend that you wa it on e hour after switching off the notebook before re moving
or installing memory modules. Otherwise, there is a risk of suffering burns!
As some components are exposed that are sensitive to static electricity, please take
note of chapter "
Notes on installing and removing boards and components", Page 52.
Removing memory modules
3
2
1
1
► Carefully push the two mounting
clips outwards (1).
Memoryexpan
sion
Memorymodul
e
The memory module snaps upwards (2).
► Pull the memory module out of its slot
in the direction of the arrow (3).
Fujitsu Technology Solutions 55
To Next Page
Loading...
