Removing and installing components
during servicing
Attaching the cover
2
1
2
2
2
2
3
► Place th e cover in the correct mounting position (1).
► Secure the scre
ws for the cover of the hard disk service compartment (2).
► Secure the screw fo r the cover of the memory service compartment (3).
► Insert the bat
tery (see Cha p ter "
Inserting battery", Page 31).
Finishing component removal
After you have removed or changed the system components as you required, please
prepare your device for operation again as follows:
► Install the battery again ( see "
Inserting battery", Page 31).
► Turn the n
otebook the right way up again a nd place it on a flat surface.
► Re co nnect the cables that you disconnected before.
58 Fujitsu Technology Solutions
To Next Page
Loading...
