Security functio ns
Activating system protection
► Start the BIOS Setup Utility and go to the Security menu.
Operatings ystem
► Select the Password on Bo ot option and press the Enter key.
► Select the desired option (Disabled, First Boot or Every Boot) and press the Enter key
► Select the Save Changes & Exit option unde r Exit.
The notebook will reboot. You will be prompted to enter your p assword (the supervisor password).
Deactivating system protection
► Start the BIOS Setup Utility and go to the Security menu.
Operatings ystem
► Select the Password on Bo ot option and press the Enter key.
► Select the Disabled option and press the Enter key.
If you do not want to change any other settings, you can exit BIOS Setup Utility.
► Select the Save Changes & Exit option unde r Exit.
The n otebook will reboot. The system is no longer password-protected.
Password protection for the hard disk
Passwordpr otec
tion:
The had disk password prevents unaut horised access to the hard disk drives
and is checked intern ally each t ime the system is booted. The condition for this
is that you have assigned at least the supervisor password.
Activating hard disk protection
► Call up the BIO
SSetupand select the Security menu.
If you have not assigned BIOS passwords yet, define the supervisor and the user
password now, if desired (see "
Secu rity functions", Page 53).
► Mark the Har
d Disk Security field and press the Enter key.
► In the Drive0 are a mark the Set Master Password field and press the Enter key.
Enter new P
assword then appears and you are asked to enter a passwo rd.
► Enter the password and press the Enter k ey.
Confirm ne
w Password requires you to confirm the password.
► Enter the pa ssword again and press the En ter key.
Setup Not
ice: Changes h av e b ee n saved is displayed to confirm that the
new pass
word has been saved .
► To assign the password for the second hard disk (Drive1), go to the Drive1 area and
select the field Set M aster Password, then proceed in exactly the same way as for
setting up the password for the first hard disk (Drive0).
The fie
ld Password Entry on Boot is set to Enabled by default. You can exit the BIOS
Setup
once you have finished changing the settings.
► From the Exit menu, choose the option Exit Saving Changes.
► Pres
s the Enter key and select Yes.
The notebook reboots and your hard disk is now protected with a password. The system
will ask you to enter the password when the notebook is restarted again.
56 Fujitsu Tech nology Solutions
Downloaded from LpManual.com Manuals
To Next Page
Loading...
