Working with the notebook
Optical drive
Opticaldrive
This product contains a light emitting diode, classified in accordance with IEC
8251:1993: LASER CLASS 1, and must therefore not be opened.
Handling d ata carriers
Handling
Observe the following guidelines whe n handling data carriers:
• Avoid touching the surface of a data carrier. Only han dle data carriers by th eir edges.
• Always store data carriers in their cases. This will protect the da ta carrier against
being covered in dust, scratched or damaged in any other way.
• Protect your data carriers against dust, mechanical vibrations and direct sunlight.
• Avoid storing a data carrier in areas subject to high tempe ratures or humidity.
You may use both 8-cm and 12-cm data carriers in the optical drive.
When using a data carrier of lesser quality, vibrations and reading errors may occur.
CD/DVD indicator
CD/DVDindicato
r
The CD/DVD indicator flashe s when a data carrier is inserted. The indicator goes out when
the drive is ready for reading. The indicator lights up when the drive is being accessed.
You may only r emove the data carrier when the indicator is unlit.
If the CD/DVD indicator does not go out after a data carrier has been inserted, but
instead continues to flash, this mean s that the drive cannot access the data carrier.
Either the data carrier is damaged or dirty or you are using a da ta
carrier that the drive cannot read.
Fujitsu Technology Solutions 67
To Next Page
Loading...
