Fujitsu MCJ3230AP - Page 22

Contents
C156-E205-01EN
x
vii
Table 4.12 IO and Cod 4-11
Table 4.13 Bit definitions of ATAPI Status register 4-11
Table 4.14
Table 4.15
Table 4.16 LED indications 4-20
Table 4.17 Command codes and parameters 4-21
Table 4.18 CHECK POWER MODE command 4-22
Table 4.19 Power mode indication 4-22
Table 4.20 DEVICE RESET command 4-23
Table 4.21 EXECUTE DEVICE DIAGNOSTIC command 4-23
Table 4.22 Self-diagnosis detailed code 4-24
Table 4.23 FLUSH CACHE command 4-25
Table 4.24 GET MEDIA STATUS command 4-25
Table 4.25 Error register 4-26
Table 4.26 IDENTIFY PACKET DEVICE command 4-26
Table 4.27 Device parameter information (1/5) 4-27
Table 4.28 IDLE IMMEDIATE command 4-33
Table 4.29 NOP command 4-33
Table 4.30 PACKET command 4-34
Table 4.31 SET FEATURES command 4-35
Table 4.32 FR register setting value 4-35
Table 4.33 Transfer setting values in the SC register 4-36
Table 4.34 Cylinder Low register 4-36
Table 4.35 Cylinder High register 4-36
Table 4.36 SLEEP command 4-37
Table 4.37 STANDBY IMMEDIATE command 4-38
Table 4.38 Packet command codes and parameters 4-39
Table 4.39 ERASE command 4-40
Table 4.40 FORMAT UNIT command 4-41
Table 4.41 FORMAT UNIT parameter list 4-41
Table 4.42 Defect list header 4-41
Table 4.43 INQUIRY command 4-42
Table 4.44 INQUIRY data 4-43
Table 4.45 MODE SELECT (6) command 4-44
Table 4.46 Mode parameters 4-44
Table 4.47 Mode parameter list 4-45
Table 4.48 Mode parameter header 4-45
Table 4.49 Block descriptor 4-45
Table 4.50 Mode Page Format 4-46
Table 4.51 Read-Write error recovery page 4-46
Table 4.52 Changeable values in the read-write recovery page 4-47
Table 4.53 Default values for the read-write recovery page 4-47
Table 4.54 Flexible disk page 4-48