Contents
xvi C156-E205-01EN
Figure 4.10 Ultra DMA data out transfer (continuous transfer timing) 4-85
Figure 4.11 Ultra DMA data out transfer (device stop timing) 4-86
Figure 4.12 Ultra DMA data out transfer (host suspend timing) 4-87
Figure 4.13 Ultra DMA data out transfer (device end timing) 4-88
Figure 4.14 Power-on and reset timing 4–90
Figure 5.1 Optical disk drive front view (with panel) 5-2
Figure 5.2 Inserting cartridge 5-4
Figure 5.3 Removing cartridge 5-5
Figure 5.4 Optial disk cartridge 5-7
Figure 5.5 Write protect tab 5-8
Figure 5.6 How to stick an index label on the MO cartridge 5-9
Figure 5.7 Cleaning procedure (1) 5-12
Figure 5.8 Cleaning procedure (2) 5-13
Figure 5.9 Cleaning procedure (3) 5-13
Figure 5.10 Cleaning procedure (4) 5–14
Figure 6.1 Revision label 6-4
Figure 6.2 Revision number indication 6-4
Tables
Table 2.1 Model and order number 2-1
Table 2.2 Specifications 2-2
Table 2.3 Environmental and power requirements 2-4
Table 2.4 Recommended optical disk cartridge specifications 2-7
Table 2.5 Disk specifications 2–10
Table 3.1 Temperature requirements at measurement points 3-3
Table 3.2 Temperature at each measuring point (Reference) 3-4
Table 3.3 Cable connector specifications 3–13
Table 4.1 Connector pin assignments 4-2
Table 4.2 Signal description 4-4
Table 4.3 I/O port functions and mapping 4-6
Table 4.4 Bit definitions of Alternate Status register 4-7
Table 4.5 Bit definitions of Device Control register 4-7
Table 4.6 Bit definitions of Drive Address register 4-8
Table 4.7 Bit definitions of ATAPI Byte Count register 4-8
Table 4.8 Bit definitions of ATAPI Block Device Select register 4-9
Table 4.9 Bit definitions of Error register 4-9
Table 4.10 Bit definitions of ATAPI Features register 4-10
Table 4.11 Bit definitions of ATAPI Interrupt Reason register 4-10
To Next Page
Loading...
