EasyManua.ls Logo

Fujitsu PRIMERGY RX2530 M5 - Page 72

Fujitsu PRIMERGY RX2530 M5
106 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
72 Operating Manual RX2530 M5
Starting up
Example HVDC PSU 380 V
V CAUTION!
The HVDC PSU adjusts automatically to any power voltage in the range
from 200 V – 380 V. You may only operate the server if its rated voltage
range corresponds to the local mains voltage.
Figure 23: Connecting the server to the DC voltage - example HVDC PSU 380 V
Ê Push the power cord plug into the PSU connector until it clicks in. The nose
of the power cord plug (A) engages in the recess of the PSU connector (B).
Ê Ensure that the status indicator on the PSU is lit green, see section
"Indicator on hot-plug PSU" on page 42.
Ê If necessary, make a permanent connection to the distribution board.
V CAUTION!
If the server/rack is intended for permanent connection to the mains
only an authorized specialist (electrician) is allowed to work.
Please follow the regulation of each country.
I It will take about 60 seconds until the server can be powered on.
A
B

Table of Contents

Related product manuals