86 Operating Manual RX2540 M5
I Configuring the RAID array, see the documentation of the RAID
controller, used in your configuration, see section "Documentation
overview" on page 13.
6.2.2 Installing 2.5-inch HDD/SSD modules
6.2.2.1 Removing a 2.5-inch HDD/SSD dummy module
Figure 30: Removing a 2.5-inch HDD/SSD dummy module
Ê Press both tabs together (1) and pull the dummy module out of its bay (2).
V CAUTION!
Keep the dummy module for future use.
Always replace dummy modules into unused HDD/SSD bays to comply
with applicable EMC regulations and satisfy cooling requirements.
To Next Page
Loading...
