RX2540 M5 Operating Manual 93
7 Troubleshooting and tips
V CAUTION!
Follow the safety instructions in the "Safety Notes and Regulations"
manual or " 安全上のご注意 " and in chapter "Important information" on
page 45.
If a fault occurs, attempt to resolve it using the measures described:
– in this chapter,
– in the documentation for the connected devices,
– in the help systems of the software used.
If you fail to correct the problem, proceed as follows:
Ê Make a list of the steps performed and the circumstances that led to the fault.
Also make a list of any error messages that were displayed.
Ê Switch off the server.
Ê Contact our customer service team.
I The meaning of the error message is explained in the documentation for
the relevant components and programs, available online at
http://manuals.ts.fujitsu.com.
Power-on indicator remains unlit after you have switched on your device
Cause Troubleshooting
Power cable
incorrectly connected
Ê Ensure that the power cable(s) is/are correctly
connected to the server and the grounded power
outlet(s).
Power supply
overloaded
Ê Disconnect the server power plug(s) from the
grounded power outlet(s).
Ê Wait a few minutes before you plug it/them into
the grounded power outlet(s) again.
Ê Switch on your server.
To Next Page
Loading...
