90 Operating Manual RX2540 M5
Figure 36: Installing the cable tie
Ê Only for AC-PSU: Push the cable clamp into the corresponding hole until it
clicks in.
Ê Connecting the power cord to the PSU, see section "Connecting the power
cord" on page 71.
Ê If applicable, configure the redundant power supply.
6.4 Cleaning the server
V CAUTION!
Switch off the server and disconnect the power plugs from the properly
grounded power outlets.
Do not clean any interior parts yourself; leave this job to a service
technician.
Do not use any cleaning agents that contain abrasives or may corrode
plastic.
Ensure that no liquid enters the system. Ensure that the ventilation areas
of the server and the monitor are clear.
Do not use any cleaning sprays (including flammable types). It may
cause a device failure or a fire.
Clean the keyboard and the mouse with a disinfecting cloth.
To Next Page
Loading...
