RX300 S5 Operating manual 101
CSS components Non-hot-plug components
8.2.1 Replacing a memory module
Ê Remove the housing cover (see section "Opening/closing the housing" on
page 106).
The slots for the memory modules can be found under the air cowl.
8.2.1.1 Removing the air cowl
Figure 31: Removing the air cowl
I If you have installed an SAS/SATA RAID controller with a BBU: pay
attention to the BBU cable (see circle) when lifting off the air cowl! If you
want to remove the air cowl from the server completely, first disconnect
the BBU cable.
Ê Take hold of the air cowl by the green touch points, and lift it up and off.
To Next Page
Loading...
