Fujitsu PRIMERGY RX300 S5 - Removing a Defective Memory Module; Installing a New Memory Module

102 Operating manual RX300 S5
Non-hot-plug components CSS components
8.2.1.2 Removing a defective memory module
Figure 32: Removing a memory module
Ê Press the holders on either side of the mounting location concerned
outward (1).
Ê Pull the memory module out of the slot (2).
8.2.1.3 Installing a new memory module
V CAUTION!
Please note the equipping rules in the technical manual for the system
board D2619.
Figure 33: Inserting a memory module
Ê Carefully press the memory module into the slot (1) until the fastening tabs
on both sides of it engage (2).
Pay attention to the plug coding.
/
/
0
/
0
0