52 Operating manual RX300 S5
Installing/removing the server in/from the rack Hardware installation
4.2.3 Installation in 3rd party racks
I The support systems from Fujitsu Technology Solutions are suitable for
use in any 3rd party racks for standard servers (installation depth 735 -
770 mm without restrictions.
Ê Refer to the manual from the rack manufacturer for details of the mechanical
installation and the climatic conditions.
V CAUTION!
When installing in 3rd party racks, it must be ensured that an air flow
from the front to the back of the rack is guaranteed.
Ê Fit the required original parts (support bracket or cable management
system).
I Under certain circumstances, you will not be able to use some of the
parts from the rack installation kit supplied - you will need to use
original 3rd party rack parts instead.
Ê Remove the outer telescopic rail as described in page 48 (figure 8).
Inserting the server
The support systems can be used for installation depths of
735 - 770 mm. The
spring element of the support system enables the length to be adjusted as
required.
Ê Secure the support systems as described in section "Installing the support
systems" on page 49.
Ê Mount the server (see "Preparing the server" on page 50) and route the
cables as described in the original manual of the rack..
V CAUTION!
Ensure that the safety lock has been inserted before the server is
inserted (see figure 9 on page 49).
To Next Page
Loading...
