54 Operating manual RX300 S5
Connecting devices to the server Hardware installation
Three additional USB ports (1) are located on the front of the server (figure 13):
Figure 13: Front side: additional USB ports
I If components with large power requirements (e.g. external USB hard
disk drives) are connected simultaneously, these USB ports may be
switched off.
Connecting the keyboard, mouse and monitor
Ê Connect the monitor, keyboard and mouse to the standard ports of the
server (see table and figure 12 on page 53).
I If a separate graphics card is installed in a slot, the graphic controller on
the system board is automatically deactivated. The corresponding
monitor port (VGA) can not be used. Plug the data cable of the monitor
into the monitor port of the graphics card.
Ê Connect the power cable of the monitor to the mains socket strip of the rack.
I The rated current for the monitor is indicated on the technical data label
on the monitor or in the operating manual for the monitor.
111
To Next Page
Loading...
