RX300 S5 Operating manual 99
CSS components Hot-plug components
Figure 30: Removing the fans (example: fan 1)
Ê Pull the green lever on the fan handle in the direction of the arrow (1) to
release the locking mechanism, and pull out the handle (2).
Ê Pull the fan out of its mounting location by its handle.
Ê Set the fan down on the outside of the server.
V CAUTION!
Never set a removed/defective fan down inside the server. Risk of
short circuit!
Ê Open the green handle on the new fan, place the fan in the fan box and press
the handle together to engage the locking mechanism.
I The new fans are measured with explicit commands in Server
Management. Depending on the result, the corresponding LED (see
figure 29 on page 98) is set to green (fan is in order) or orange (fan is
not in order).
Ê Return the housing cover to its position (see section "Opening/closing the
housing" on page 106).
To Next Page
Loading...
