Fujitsu PRIMERGY RX600 S5 - Installing a New Memory Module; Reinstalling the Memory Board in Question

RX600 S5 Operating Manual 119
CSS components Hot-plug components
8.1.5.4 Installing a new memory module
V CAUTION!
Observe the safety information concerning memory modules in section
"Removing a defective memory module" on page 117.
Figure 36: Installing a memory module
Ê Carefully press the memory module into the slot (1) until the fastening tabs
on both sides of it engage (2).
8.1.5.5 Reinstalling the memory board in question
Figure 37: Installing a memory board
Ê Slide the memory board down (1) in the lateral guide channels until it stops.
Swivel the levers in the direction of the arrows (2).
Ê Make sure that the green locks on the top engage.
/
0
0
0 0
/