Fujitsu PRIMERGY RX600 S5 - Indicators on the Hot-Plug HDD Modules

68 Operating Manual RX600 S5
Control elements and indicators Starting up and operation
© cognitas. Gesellschft für Technik-Dokumentation mbH 2010 Pfad: C:\Programme\FCT\tim_app\tim_local\work\PICHOL\OBJ_DOKU-4888-003.fm
5.1.1.4 Indicators on the hot-plug HDD modules
Figure 14: Indicators on a hot-plug HDD module
If a hard disk drive continuously indicates an error, the drive should be replaced
as soon as possible. This can be done during operation (see "Hot-plug HDD
modules" on page 100).
1 HDD BUSY (green)
– Lights up: HDD in active phase (drive active, drive being accessed)
– Does not light: HDD inactive (drive inactive)
2 HDD FAULT (orange)
– Does not light: no HDD error
– Lights up: HDD Faulty or Rebuild Stopped (drive defective/needs
replacing, a rebuild process was stopped or the HDD module is not
correctly inserted)
– Slow flashing: HDD Rebuild (the data is being restored after changing
a drive)
햲 햳