Fujitsu PRIMERGY RX900 S2 - Page 63

RX900 S2 Operating Manual 63
Hardware installation
Removing the inner part of the rail
Figure 7: Removing the inner part of the rail
Ê Extend the threepart rail fully.
Ê Unlock the inner part of the rail by pressing the locking lever (1). Remove the
inner part of the rail (2).
Ê Repeat the steps with the second rail.
Installing the rail in the rack
The figure 8 shows the positioning of the rail in the rack where (A) indicates the
position of the cage nuts.
/
0