66 Operating Manual RX900 S2
Hardware installation
Inserting the server
Figure 10: Inserting the server
Ê Pull the middle parts of the rails out of the rack completely until they click into
place (1).
I The middle parts of the rails must click into place so that they can no
longer be moved.
Ê Place the server in module direction as close as possible in front of the rack
and lift it to the mounting position.
V CAUTION!
Due to the heavy weight, a suitable lifter is required to lift the server
to the mounting position. Make sure that the lifter is locked into place
before you start to mount the server.
Ê Insert the inner parts of the rails that are mounted on the server into the
protruding middle parts until the rails engage (2).
Ê Release the locking mechanism of both rails (3).
– Left side oft the server: Push upward
– Right side of the server: Push downward
/
0
1
2
2
3
3
3
3
To Next Page
Loading...
