TX120 S3 Operating Manual 45
Hardware installation
5.2 Setting up the server
Ê Set up the server.
I Note that the server may be operated in the vertical (see section
"Positioning the server vertically" on page 46) or horizontal position
(see section "Positioning the server horizontally" on page 49).
V CAUTION!
– The device must be protected from direct sunlight.
– The required minimum distances for operation and maintenance
areas must be adhered to.
– The server must be accessible at the rear for connection to other
devices (e.g. memory subsystem).
– The mains plug must be accessible easily and safely.
– There must be a clearance of at least 200 mm in front of and
behind the server to ensure adequate ventilation of the system.
Ê Wire the server. Follow the instructions in sections "Connecting devices to
the server" on page 51 and "Notes on connecting/disconnecting cables" on
page 54.
Ê Connect the server to the mains (see section "Connecting the server to the
mains" on page 52).
To Next Page
Loading...
Need help?
General