80 Options Guide U41629-J-Z156-2-76
Cabling Appendix
13.1.2 SATA version
SATA version with onboard SATA controller
In the basic version the four internal hard disk drives are connected to the
onboard SATA controller via a special SATA cable.
If a tape drive will be installed it is necessary to install a SCSI controller in a PCI
slot and to connect the SCSI controller with the tape drive.
SATA version with additional SATA RAID controller
A SATA RAID controller is installed into a PCI slot and connected with the four
internal hard disk drives via a SATA cable.
In this case, the SATA connections to the onboard SATA controller must be
removed. The SATA LED cable has to be removed from the SATA backplane and
the system board and is no longer used.
If a tape drive will be installed it is necessary to install a SCSI controller in a PCI
slot and to connect the SCSI controller with the tape drive.
To Next Page
Loading...
