Fujitsu PRIMERGY TX200 S6

TX200 S6 Service Supplement 11
Documentation overview
Extensions and upgrades:
I For some components only the installation
routine is described in the Options Guide.
Removing these components proceed in
reverse order.
– Extending/replacing the main memory
– Installing a second processor / replacing the
processor / replacing the heat sink
– Installing accessible drives, like slimline DVD,
multibay etc.
– Installing a hard disk extension box
– Installing a LSP/LSD
– Installing expansion cards
– Installing BBU
– Installing TPM
– Installing UFM
– Installing a second serial connector
– Converting to hot-plug PS and to redundant
fans
– Converting from the floorstand model to the
rack model
Options Guide
Cabling
Replacement routines:
– Replacing the front panel module
– Replacing the standard PSU
– Replacing the Power backplane
– Replacing the 3.5“ HDD backplane
– Replacing the 2.5“ HDD backplane
– Replacing the intrusion switches
– Replacing the IDTEMP combo
– Replacing the TPM
– Replacing the UFM
– Replacing the system board
Service Supplement
Board layout
BIOS setup BIOS Setup
Information/procedure Manual
Table 1: Overview of the documentation TX200 S6