24 Service Supplement TX200 S6
Preparation
4.1.2 Rack model
I You will find a detailed description of "Opening the server" and
"Removing the rack front cover" in the Options Guide TX200 S6.
4.1.2.1 Opening the server
Ê Terminate all applications and shut down the server correctly.
Ê If your operating system has not switched off the server, press the On/Off
button for at least four seconds.
Ê Pull all power cords out of the power outlet.
Ê Disconnect all cables on the rear side of the server.
Ê Loosen the two knurled screws on the front and pull the server as far as
possible out of the rack.
Ê Pull the locking lever as far as it will go. This pushes the top cover backward.
Ê Remove the top cover.
Remove the server from the rack cabinet, if it is not sufficiently accessible.
Please refer to the Options Guide for a detailed description.
V CAUTION!
At least two people are needed to lift the server out of the rack cabinet.
Ê Loosen the two knurled screws on the front and pull the server as far as
possible out of the rack.
Ê Pull the locking bar forward on both sides.
Ê Lift the server out of the rails and place it on a table, for example.
Ê Pull the locking lever as far as it will go. This pushes the top cover backward.
Ê Remove the top cover.
To Next Page
Loading...
