TX200 S6 Service Supplement 23
4 Replacement routines
V CAUTION!
Follow the safety instructions in the chapter "Safety instructions" on
page 15.
4.1 Preparation
4.1.1 Floorstand model
I You will find a detailed description of "Opening the server" and
"Removing the front cover" in the Options Guide TX200 S6.
4.1.1.1 Opening the server
Ê Terminate all applications and shut down the server correctly.
Ê If your operating system has not switched off the server, press the On/Off
button for at least four seconds.
Ê Pull all power cords out of the power outlet.
Ê Pull the locking lever of the side cover as far as it will go. This pushes the
side cover backward.
Ê Remove the side cover.
4.1.1.2 Removing the front cover
The following replacement routines require removing the front cover:
– Replacing the front panel module
– Replacing the intrusion switches
– Replacing the IDTEMP combo
Ê Release the three locks at the left side and open the front cover.
Ê Unhook the front cover at the other side and remove the front cover.
To Next Page
Loading...
