EasyManuals Logo

Fujitsu RAID 0/1 SAS based on LSI MegaRAID User Manual

Fujitsu RAID 0/1 SAS based on LSI MegaRAID
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #108 background imageLoading...
Page #108 background image
108
Modular RAID Controllers
Modular RAID 12Gb/s (SAS3.0)
5.6.1 Features
The RAID controller "PRAID EP440i" implements the LSI SAS3108 which is an
integrated SAS and I/O controller with dual embedded Power PC 476 cores
running at speeds up to 1.2 GHz. The LSI SAS3108 also provides the following
functionalities:
Provides an 8-lane 5.0 / 8.0 Gbit PCIe 3.0 host bus.
Provides an 8-port 12Gb/s SAS3 and 6Gb/s SATA3 interface.
Provides a 1866 MHz DDR3 SDRAM interface with a hardware RAID assist
engine for parity calculations.
Provides a full-featured hardware-based RAID solution that supports RAID
levels 0, 1, 1E, 5, 6, 10, 50 and 60.
Six I
2
C interfaces used for Serial Boot strap ROM connection, memory
detection, PCI-E SMBus connectivity, battery / smart charger control, and
SAS sideband control.
Integrated dual UART for MegaRAID
®
diagnostic use only.
Two banks of SGPIO signals to accompany the two sets of x4 SAS / SATA
ports.
16MB Flash
1kB Bootstrap EEPROM
Mounting holes for TFM
Raid-key chip onboard

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu RAID 0/1 SAS based on LSI MegaRAID and is the answer not in the manual?

Fujitsu RAID 0/1 SAS based on LSI MegaRAID Specifications

General IconGeneral
BrandFujitsu
ModelRAID 0/1 SAS based on LSI MegaRAID
CategoryController
LanguageEnglish

Related product manuals