Fujitsu ScanSnap S510M User Manual

222
6. Remove the pick roller with its shaft.
Slightly pull up the left part of the pick roller shaft (about 5mm), move it towards the left
side, and then raise it to remove from the ScanSnap.
ATTENTION
If the area around the pick roller is dirty by paper-powder, it may cause a
scanning error. Remove the dirt using a dry cloth moistened with
Cleaner F1.
* Do not use water, mild detergent or air-spray.
Pick roller shaft
Pick roller

Fujitsu ScanSnap S510M Specifications

General

Brand	Fujitsu
Model	ScanSnap S510M
Category	Scanner
Language	English