17
- First-time setup of your tablet
Turning on the system the first time
When you switch on the device for the first time, the supplied software is installed and configured. Because this
procedure must NOT be interrupted, you should set aside enough time for it to be fully completed and connect
the device to power using the AC adapter.
Connecting the AC Adapter
The AC adapter provides power for operating your
Android Tablet and charges the battery.
1 Plug the AC Adapter cable into the AC Adapter
connector on the bottom edge of your tablet.
(Figure 4)
2 Plug the AC adapter into an AC electrical outlet.
Figure 4. Connecting the AC Adapter
During the installation process, DO NOT restart
the device unless you are requested to do so. To
make it easier to use your device for the first
time, the operating system
is pre-installed.
1 Press the On/Off switch (1) for 2 seconds to
switch the Android Tablet on.
2
During installation, follow the instructions
on screen.
Figure 5. Powering on the system
To Next Page
Loading...
Need help?
General