Fukuda VaSera VS-2000 Series - Using SD Card for Patient Data

4-9
Chapter 4 Entering Patient Information
Using Patient Information Registered to an
SD Card (Patient File Selection)
Patient information entered when conducting an examination can be registered to an SD card and then called and used again for
the next examination.
• Set [General/ID-A.C.] - [Patient Information Reference] to "Patient file selection" to use the function for registering
patient information.
• The following patient information can be registered: ID number, name, date of birth, gender, height, weight and Dept.
1-4. Enter a date of birth, not an age, as the patient's age will be different at each examination. (Refer to "Entering the
Basic Information" (P4-3).)
• Insert an SD card in the SD card slot and format it beforehand. (Refer to "Initialization" (P9-4).)
• A maximum of 5,000 patient data can be registered to the SD card, but this number may vary depending on the capacity
of the SD card that is used and the content that is recorded. Use only an SD card specified by Fukuda Denshi.
Registering the Patient Information
Enter the patient information, perform the examination and then save the patient information to the SD card.
1 Insert a formatted SD card in the SD
card slot.
2 Enter the patient information and
perform the examination.
When the examination is completed, the patient
information used in the examination is automatically
registered to the SD card.
The message "There is no patient information registration
environment on the SD card. Create a registration
environment?" is displayed when registering patient
information for the first time. Touch [Yes].
• The patient information is registered to the SD card
immediately after the examination is completed.
Removing the SD card or turning OFF the power too
soon may damage the SD card.
• The examination result will not be saved if the power is
turned OFF with the examination screen displayed.
Make sure to touch [Back] before turning OFF the
power.
Loading the Patient Information Using the ID Number
Use the ID number to load the patient information from the SD card.
1 Touch the patient information display
area.
2 Enter the ID number.
1) Touch the number buttons to enter the ID
number.
2) Touch [ ].