2. WIRING
2-4
Note:
To satisfy the requirements for IPX5 waterproof rating, the cable used must
have a diameter of 14.4 mm (±0.4 mm).
1. Unfasten the four screws on the rear cable clamp, then remove the cable clamp
to reveal the WAGO connector.
2. Fit the cable gasket to the cable clamp, referring to the figure below.
3. Pass the cabling through the cable gasket and cable clamp.
4. Fit the cover gasket (rubber seal) to the rear of
the display unit. Make sure the rubber seal is
placed inside the groove indicated in the figure
below.
5. Connect the cabling to the display unit, referring to the interconnection diagram at
the back of this manual.
6. Slide the cable clamp along the cable until the clamp is flush against the rear of
the display unit.
Note: The cable clamp must be oriented with the dome facing upwards in order
to retain it’s waterproofing rating.
7. Fasten the four screws removed at step 1.
8. Secure the cables to the cable clamp with cable ties.
Fixing lip
Cable clamp Cable gasket
1. Fit the cable gasket to the cable clamp,
passing the fixing lip partially through
the cable clamp.
2. To pass the fixing lip completely
through the cable gasket, twist the
cable gasket gently.
3. Check that the cable gasket is flush
against the cable clamp, as shown
below.
4. Check that the cable gasket’s fixing
lip is flush against the inside of the
cable clamp.
Fixing lip
WAGO lever
Groove for
rubber seal
To Next Page
Loading...
