2. WIRING
2-7
2.4.3 How to connect the cables
Some parts or wiring have been omitted from the illustrations for clarity.
Note:
When closing the distributor unit, make sure that the connected cables do not
contact the cover.
How to open/close the top cover
Unfasten nine screws to open the top cover.
After the appropriate cable connections are com-
pleted, fasten nine screws to close the top cover.
Cable entrance
There are two layers at the cable entrance on the
front side of the distributor unit, upper and lower
entrances.
First, loosen two screws to remove the upper protector. The upper cable entrance ap-
pears. Then, loosen two screws to remove the lower protector. The lower cable en-
trance appears.
Set each cable on the cable entrance, referring to "Cable entrance" on page 2-8 then
fasten the cable as follows with two cable ties which are supplied locally.
Note: If the cable is too thick for the protector to hold, bend the protector with a plier
supplied locally.
Upper protector
Upper entrance Lower entrance
Lower protector
Example for fastening cable
LAN cable
Fixing plate for
LAN cable
SIDE VIEW
Cable tie
LAN
connector
LAN
connector
Two cable
ties on the
vinyl tape
A cable tie on
the sheath
DST board
65P6110
Fixing plate for
LAN cable
To Next Page
Loading...
