2. WIRING
2-8
Also, the lane for each cable is shown below, referring to the Wiring Label attached on
the reverse side of the top cover.
Cable connection (other than the power cable)
Connect the cables to the connectors on the DST board 65P6110 and the LIF board
65P6111 (option). The core lines of the cables should be connected to the connectors
referring to the interconnection diagram at the back of this manual.
The type of cable to be connected and the cable location on the cable entrance are
shown in the following figure and table.
The LIF board
Cable entrance
Cable entrance viewed from
inside of the distributor unit
Upper entranceUpper entrance
Upper protectorUpper protector
Lower protectorLower protector
Lower entrance
For a thick cable, bend the protector with a plier.
CN4
CN3
CN2
CN18
CN19
CN20
CN17
CN21
CN22
CN5
CN8
CN13
CN14
CN15
CN6
CN7
CN11
CN12
CN9
CN10
DST board 65P6110
LIF board*
65P6111
CN16
Connector location
*: If LIF board is not
attached in distrib-
utor unit, the board
is provided with
the optional kit
OP65-3.
To Next Page
Loading...
