Furuno DSC-6 - 9. How to update system program

Content
11
Section H3. FELCOM 82
1. Connection ..................................................................................................... 1
2. System settings .............................................................................................. 2
2.1 Heading alignment........................................................................... 2
2.2 Telephone setting............................................................................. 3
2.3 Fax setting (PFX-50)........................................................................ 4
2.4 Gyro setting ..................................................................................... 6
2.5 Setup NAV data input circuit .......................................................... 10
2.6 Entering answer back code (only for class-1)................................. 11
2.7 OID/DID setting.............................................................................. 12
2.8 HSD set up .................................................................................... 19
2.9 About password ............................................................................. 20
2.10 Returning settings to factory defaults........................................... 22
3. Self-test ........................................................................................................ 23
3.1 Using handset ................................................................................ 23
3.2 Using terminal unit ......................................................................... 24
3.3 Reading program number............................................................... 25
3.4 Distress alert test (FUNC683)........................................................ 26
3.5 Status monitor ................................................................................ 28
3.6 Using two-digit code service (Loopback test)................................. 36
3.7 9.6k Data test................................................................................. 37
3.8 HSD test ......................................................................................... 38
3.9 LED status...................................................................................... 40
3.10 How to check angular rate sensor................................................ 45
3.11 How to check rotary joint ............................................................. 45
3.12 Error Messages at the Terminal Unit............................................ 46
4. Program Update ........................................................................................... 51
4.1 Connection..................................................................................... 52
4.2 Upgrading SYSTEM, DEMOD, SYNC, DECODE,
and TERM programs ...................................................................... 53
4.3 Upgrading handset program .......................................................... 55
4.4 Upgrading terminal program .......................................................... 57
5. Menu tree ..................................................................................................... 58
5.1 Menu on handset ........................................................................... 58
5.2 Menu on terminal unit (Class1)...................................................... 61