Furuno FS-1503 - Chapter 4 System Settings

4-1
The system channels list is shown on the next page. The system channels marked * can
only be set by a Furuno service agent or dealer. These channels can be recalled by enter-
ing the password. The procedure for changing user settable system settings appears in the
Operator's Manual.
The figure below shows the setting-up procedure of the FS-1503.
S
y
stem Channel 9998 Settin
g
(
Select 0 or 1
)
Changing System Settings
Power ON
Registering User - Channel
0-01 to 99channel
1-00 to 99channel
TX/RX Frequencies
Adjusting TX Power
Hi
g
h - Power
([ENT] + [8])
Low - Power
([ENT] + [9])
Tune - Power
([ENT] + [7])
Channel Name
(7 Letters)
[CH] + Power ON
CH9999
→
[CH], Password [ENT]
CH99xx
→
[CH], Changing Setting, [ENT]
0: TX/RX Freg. Setting and Power Adj.
1: TX/RX Freg. Setting
Resettin
g
S
y
stem Channel 9998
Power OFF
Power OFF
→
ON
Power OFF
→
[CH] + Power ON
0 - 01 to 65
Chapter 4 System Settings