4-10
How to erase programmed frequency
1. Follow steps 1 to 5 described in “How to program user channel” on page 4-8.
2. Select an RX channel to be erased by rotating the FREQ/CH knob.
(For example, 0-010R)
3. Press [CH], [0], and [ENT] in this order.
4. Rotate the FREQ/CH knob cw by one click to select the TX channel.
(For example, 0-01T)
5. Press [CH], [0], and [ENT] in this order.
To erase another user channel, repeat steps 2 to 5. All user channels can be erased at a
time: On system channel 9901 press [CH], [1], and [ENT] in this order.
How to erase channel name
1. Select a channel name to be erased. (Carry out steps 1 to 5 on page 4-8, and select the
channel name by rotating [FREQ/CH] knob.)
2. Press [CH], [0], and [ENT] in this order.
How to change channel name
1.
Select a channel name to be changed. (Carry out steps 1 to 5 on page 4-8, and select
the channel name by rotating [FREQ/CH] knob.)
2. Press [CH], and then press [ENT] several times until the cursor moves onto the
character to be changed.
3. Rotate [FREQ/CH] knob to select a new character, and press [ENT].
4. Repeat steps 2 to 3.
5. Move the cursor onto the 7th character and press [ENT].
To Next Page
Loading...
