4-2
4.1 Changing System Settings
1. While pressing and holding down [CH], turn the power on. System channel 9942,
setting number 1, and MEMO appear on the screen.
9 9 4 2
1
MEMO
S
stem channel
Preset value
2. Select the system channel 9999 by rotating the FREQ/CH knob.
3. Enter a password. (Press [CH], type password, and then press [ENT].)
4. Select a channel to be changed its setting by rotating the FREQ/CH knob.
5. Change the setting. (Press [CH], enter setting number, and then press [ENT].)
6. To change another channel, repeat steps 4 and 5.
7. Turn the power off and on again to store the settings.
To Next Page
Loading...
