4-9
8. Enter a receiving frequency(R): Press [CH], enter a frequency with numeric keys, and
then press [ENT]. Reenter a frequency after pressing [CH] if necessary.
9. Rotate the FREQ/CH knob cw by one click to select the TX frequency(T) on the
same channel.
10. Enter a transmitting frequency: Press [CH], enter a frequency with numeric keys, and
then press [ENT]. If the transmitting frequency is the same as the receiving frequency,
press [ENT] without typing the frequency.
If you do not need to register a channel name, skip steps 11 through 14.
How to register channel name
11. Rotate the FREQ/CH knob cw by one click, the following display will appear.
0-01
- - - - - - -
MEMO
Channel Number
Channel Name
12. Press [CH], and select a desired number or alphabet by rotating the FREQ/CH knob.
And then press [ENT].
13. Rotate the FREQ/CH knob to select a desired alphanumeric for the next character,
and press [ENT].
14. Do the same to complete a channel name (max.7 characters). After entering the last
character, cursor disappears automatically and the channel name is registered.
15. Rotae the FREQ/CH knob cw by one click to register the RX frequency on another
channel. Or, set the system channel 9998 to the default value (2 or 3) to terminate the
setting.
16.
Turn off the power to store programmed channels.
The following pages describes how to delete a frequency and how to erase/change a
channel name.
Now that system channel 9906 must be set to “0” for displaying a channel name.
To Next Page
Loading...
