6–4
6.3 Demo Display
The demo display provides simulated opera-
tion of this unit. Own ship tracks, at the speed
selected, a figure eight course, starting from
position entered. All controls are operative;
you may change course, enter marks, etc.
1) While pressing and holding down [NU/
CU ENT], turn on the power.
_ _°
DEMO SETTING
ENT: Enter
: Column
: Cursor
_ _._ _ _' N _ _ _°_ _._ _ _' W
BASE POSITION
SPEED
00.00kt
: N/S, E/W
Figure 6-6 Simulation mode menu
2) Key in latitude of initial position.
3) If necessary, press [
] to switch from
north latitude to south latitude or vice
versa.
4) Key in longitude.
5) If necessary, press [
] to switch from east
longitude to west longitude or vice versa.
6) Press ▼ key.
7) Key in speed.
8) Press the [NU/CU ENT] key to start the
simulation mode. The plotter display ap-
pears and the simulation begins. After the
test results appear, the Simulation Mode
menu appears.
9) To quit the demo display, turn off the
power.
All tracks, marks and data entered during the
simulation are erased and default simulation
mode settings restored.
To Next Page
Loading...
