1. INSTALLATION
1-6
• Make sure there are no objects near the vent.
• Leave enough space around the unit for maintenance and servicing. The recom-
mended maintenance space appears in the outline drawing at the back of this manual.
• Observe the compass safe distances shown in the safety instructions on page i to pre-
vent interference to a magnetic compass.
Install the unit as follows:
Tabletop: Fasten with four self-tapping screws.
Bulkhead: Screw in two self-tapping screws for the upper side. Leave approximately 5
mm of the screws exposed. Hang unit on screws and tighten screws. Screw in two self-
tapping screws for lower side and tighten.
259(10.2")
90(3.54")
#85(3.34")
CABLE INLET
144±1(56.7"±0.03")
219(8.62")
VENT
#70(2.75")
255(10.0")
230±1(9.06"±0.03")
EARTH
TERMINAL
(FIXING
HOLE)
2-
φ5
(0.2")
44
(1.73")
12(0.47")
R6(0.24")
#70(2.75")
To Next Page
Loading...
