3. INITIAL SETTINGS
3-33
3.14 NAV OPTION Menu
Item Description Settings
[NAV MODE] Your vessel may go off course when navigating
between waypoints in the NAV mode. This can
happen when, for example, a command is
received from a remote controller. To get you
back on course, three methods are available:
[COURSE] and [XTE (PRECISION)], [XTE
(ECONOMY)]. For [COURSE], the NAVpilot
calculates a new course based on your new
position after dodging, etc. that takes you
directly to your destination waypoint. [XTE
PRECISION] and [XTE ECONOMY] both use
the XTE (cross-track error) value to steer the
boat towards your ORIGINAL course before
dodging. PRECISION provides for more pre-
cise steering than ECONOMY.
Note: [COURSE] is not shown in case of Fan-
tum Feedback
TM
.
[COURSE], [XTE(PRECI-
SION)], [XTE(ECONOMY)]
[NAV DATA
SOURCE]
Select the source of nav data to use in the NAV
mode. See the procedure on the next page.
[WAYPOINT
SWITCHING]
When you arrive at a waypoint on a route in the
NAV mode, you can switch to the next way-
point automatically or manually.
The [AUTO] setting will automatically switch to
the next destination waypoint when your boat
is within the arrival alarm area (set on the
chartplotter).
The [MANUAL] setting requires operator con-
firmation (pushing the knob) before switching
to the next waypoint.
[AUTO], [MANUAL],
[AFTER
ARRIVAL]
Set how the boat is to be steered after arriving
at the last waypoint in a route, in the NAV
mode. This function is not available when boat
type is selected as sailboat.
Note: For Fantum Feedback
TM
, only the items
[GO STRAIGHT] and [ORBIT TO STBD] are
available.
[GO STRAIGHT],
[ORBIT TO PORT].
[ORBIT TO STBD].
[FIGURE EIGHT TO PORT],
[FIGURE EIGHT TO STBD],
[SQUARE PORT],
[SQUARE STBD],
[NAVNET2]
The NAVpilot can automatically go to the NAV
mode when it receives a P sentence (FURUNO
proprietary) from a NavNet vx2 equipment. You
can turn this feature on or off.
This feature is
invalid when you use the FishHunter
TM
mode.
[OFF], [ON]
NAV OPTION
NAV MODE: XTE (ECONOMY)
NAV DATA SOURCE
WAYPOINT SWITCHING: AUTO
AFTER ARRIVAL:
GO STRAIGHT
NAVNET2: ON
To Next Page
Loading...
