Furuno NAVpilot-711C - Remote Controllers (Option)

2. WIRING
2-9
• FAP-7021 can be connected at the end of FAP-7001/FAP-7011 Control Unit.
2.4 Remote Controllers (option)
The Processor Unit has two ports for connection of two remote controllers.
The Distributor FAP-6800 allows you to connect three NFU (Non Follow-Up) type remote
controllers to the Processor Unit.
Note 1: Connect remote controllers that have connectors to the Distributor FAP-6800.
Note 1: The remote controllers are not available with Fantum Feedback
TM
.
Note 3: Set the remote controller type on the [SYSTEM SETUP] menu, in chapter 3.
Remote controllers with connector Remote controller without connector
FAP-5551 (dial), FAP-6211 (button),
FAP-6221 (lever), FAP-6231 (dodge)
FAP-5552 (dial), FAP-6212 (button),
FAP-6222 (lever), FAP-6232 (dodge)
PROCESSOR UNIT
BD-07AFFM-LR-150
BD-07AF-07AF-LR-100
BD-07AF-07AF-LR-100
PROCESSOR UNIT
FAP-7001/7011 FAP-7021
BD-07AF-07AF-LR-100
BD-07AF-07AF-LR-100
Termi-
nator
TB8
Max. cable length 35 m
BD-07AFFM-LR-150