3. INITIAL SETTINGS
3-15
4. Rotate the knob to set the return delay.
The setting range is 1-20 seconds.
NAV mode: When the data from the helm sensor is not input for the set time, NAV
mode is restored.
AUTO, WIND mode, etc. (except NAV mode): When cruising straight ahead and the
data from the helm sensor is not input for the set time, the previous steering mode is
restored.
5. Use the knob to select [SAFE HELM RESPONSE] then push the knob.
6. Turn the knob to set the response then push the knob.The higher the value the faster
the response. Turn the helm to port or starboard. A beep sounds and the indication
PORT or STBD on the menu appears in reverse video.
7. Press the MENU key to close the window.
8. Use the knob to select [SAFE HELM BEEP] then push the knob.
[SAFE HELM BEEP] turns the beep on of off when the safe helm mode is activated.
9. Use the knob to select [ON] or [OFF] then push the knob.
10.Press the MENU key to close the menu.
How to set the power assist mode
1. Use the knob to select [POWER ASSIST] in the [DOCKSIDE SETUP] menu then
push the knob.
2. Use the knob to select [ON] then push the knob. When this is done the menu items for
power assist appear.
3. Use the knob to select [FOR SPEEDS UNDER] then push the knob.
SAFE HELM RESPONSE
RESPONSE: 6 PORT STBD
TURN HELM PORT/STBD TO
SET SAFE HELM RESPONSE
TIME. HIGHER VALUE =
FASTER RESPONSE
PUSH MENU KEY TO CONTINUE
SAFE HELM/P.ASSIST SETUP
SAFE HELM: ON
RETURN DELAY 5 SEC
SAFE HELM RESPONSE
SAFE HELM BEEP: ON
POWER ASSIST: OFF
SAFE HELM/P.ASSIST SETUP
SAFE HELM: ON
RETURN DELAY 5 SEC
SAFE HELM RESPONSE
SAFE HELM BEEP: ON
POWER ASSIST: ON
FOR SPEEDS UNDER 3.0kn
POWER ASSIST STBY: ON
POWER ASSIST RUDDER SPEED
To Next Page
Loading...
