5-1
5. TRANSMISSION, RECEPTION
This chapter shows you how to transmit and receive Telex mes-
sages. Also included are the procedures for frequency scanning,
and automatic operation.
5.1 Manual Calling
The simplest way to communicate with a Telex subscriber is Manual
Calling. For the ARQ mode, you may display beforehand the mes-
sage to send or type message manually.
1. Press function key [F3] to display the Operate menu.
1: Call Station
2: Macro Operation
3: File to Send
4: Cancel Sending
5: Scan (Start/Stop)
6: Manual Reception
7: Timer Operation
8: High Tension ON
9: Manual Calling
0: Set Frequency
Operate
Figure 5-1 Operate menu
2. Press the [0] key. The Set Frequency screen appears.
Tx Freq: 0.00
RX Freq: 0.00
Set Frequency
Figure 5-2 Set frequency screen
To Next Page
Loading...
