11
Flush mount
1. Prepare a cutout (120x60 mm) in the mounting location, referring to the outline drawing.
2. Dismount the microphone chassis from the case to detach MIC assy.
Leave the rubber gasket attached to the MIC assy. The case may be discarded.
3. Pass wiring through the cover assy. (supplied).
4. Wire the microphone referring to paragraph 2.6.
5. Set the cover assy. to the MIC assy. and fasten with two screws.
6. Set the entire assy. to the mounting location and fasten with 12 self-tapping screws (4x16).
7. Coat area around the MIC assy. with adhesive (silicone sealant) to enhance waterproofing.
Gasket
Mounting dimensions for flush mount VR-3012W
To Next Page
Loading...
